Synthesizing a uniformly spaced array pattern using integral operator for removing progressive phase shift

In this article, an analytical technique is introduced to obtain the excitation coefficients of uniformly spaced linear antenna arrays in order to achieve a desired array factor. By integration of the prescribed array factor, the array factor dependency to the progressive phase shift is eliminated. A new system of linear equations is consequently obtained whose solution represents the excitation coefficients of the array. Some examples are presented to verify the accuracy of the introduced method. The performance of this strategy is compared with those obtained by the other well‐known techniques such as Woodward‐Lawson and Fourier transform. It is shown that the presented method estimates the desired array pattern with a very good precision.     

α径迹法用于分辨高浓铀和Pu微粒的方法研究

擦拭样品微粒分析技术是核保障环境样品分析的一种主要手段，从大量灰尘颗粒中识别并定位含高浓铀（HEU）或含Pu微粒是微粒分析首先需要解决的问题。本文以HEU和Pu微粒为研究对象，建立了用于微粒α径迹测量的样品制备方法，采用CR-39固体径迹探测器为α径迹探测器，测量了不同蚀刻时间2种微粒产生的α径迹星的径迹参数。结果表明：可通过测量径迹短轴与曲率直径并作图来分辨HEU和Pu微粒，该方法对于蚀刻时间大于10 h的微粒径迹星，均能明显分辨，对于径迹非常密集的径迹星，也能准确分辨。     

浅谈不同给液方式在铜电解车间的应用

不同给液方式对铜电解过程中有重要的影响,不同的循环方式会影响槽内温度分布、电解液成分及阳极泥沉降等,因此,根据铜电解生产不同情况的需要,分析对比了多种给液方式在贵冶电解车间的应用,总结了这几种给液方式的优缺点和适用条件。     

一种压电半导体纳米线的热电耦合性能研究

采用有限元分析方法,研究了一种n型压电半导体纳米线(氧化锌)的电热耦合性能,分析了外部温度对氧化锌纳米线内部机械场、电场及电流场分布的影响,并讨论了本构方程线性化对电学参数的影响。研究结果表明,温度对氧化锌纳米线的电场、载流子浓度和电流密度影响很大,采用线性本构和非线性本构求得的电场、电子浓度和电流密度最大相差分别为24%,32%和68%,基于非线性本构分析压电半导体的电学性能会引起很大误差。该研究结果可为压电半导体器件利用温度调控电场、电流提供理论依据。     

基于Bootstrap方法的密封寿命可靠性评估

针对高可靠、长寿命密封件在小样本试验下的可靠性寿命评估需求,提出一种基于虚拟增广样本和Bootstrap方法的密封寿命小样本数据可靠性评估方法。并以轴用阶梯圈为例,进行寿命可靠性评估。首先通过虚拟增广法将轴用阶梯圈台架寿命试验数据样本数增广至10个,使得样本数满足Bootstrap方法的适用条件;然后再利用Bootstrap方法得到轴用阶梯圈的寿命可靠性评估结果。     

Adomian decomposition method for the MHD flow of a viscous fluid with the influence of dissipative heat energy

An investigation is carried out on the effect of dissipative heat energy on the flow of an electrically conducting viscous fluid past a shrinking sheet. Both viscous and Joule dissipation effects are considered along with heat generation/absorption for the enhancement of heat transfer properties. The governing nonlinear coupled partial differential equations are transformed into nonlinear ordinary differential equations by a suitable choice of similarity transformations. However, the complex transformed equations are solved by an approximate analytical method known as the Adomian decomposition method with a suitable initial guess solution assumed from the known initial conditions. Moreover, the behavior of several parameters characterizing the flow phenomena are studied via graphs and the numerical computations for the engineering coefficients are obtained and presented through tables. However, the major outcomes of the results are that a higher suction is required to resist the fluid temperature and sinks as well as the dissipative heat energy favors enhancing the fluid temperature at all points in the flow domain.     

Short communication: In vitro rumen gas production and starch degradation of starch-based feeds depend on mean particle size

Our objective was to model the effect of mean particle size (mPS) on in vitro rumen starch degradation (IVSD) and the kinetics of gas production for different starch-based feeds. For each feed, 2 batches of the same grains were separately processed through 2 different mills (cutter or rotor speed mills), with or without different screens to achieve a wide range of mPS (0.32 to 3.31 mm for corn meals; 0.19 to 2.81 mm for barley meals; 0.16 to 2.13 mm for wheat meals; 0.28 to 2.32 mm for oat meals; 0.21 to 2.36 mm for rye meals; 0.40 to 1.79 for sorghum meals; 0.26 to 4.71 mm for pea meals; and 0.25 to 4.53 mm for faba meals). The IVSD data and gas production kinetics, obtained by fitting to a single-pool exponential model, were analyzed using a completely randomized design, in which the main tested effect was mPS (n = 6 for all tested meals, except n = 7 for corn meals and n = 5 for sorghum meals). Rumen inocula were collected from 2 fistulated Holstein dairy cows that were fed a total mixed ration consisting of 16.2% crude protein, 28.5% starch, and 35.0% neutral detergent fiber on a dry matter basis. The IVSD, evaluated after 7 h of rumen incubation, decreased linearly with increasing mPS for corn, barley, wheat, rye, pea, and faba meals, and decreased quadratically with increasing mPS for the other meals. The y-axis intercept for 7-h IVSD was below 90% starch for corn, barley, and rye feeds and greater than 90% for the other tested feeds. The mPS adjustment factors for the rate of rumen starch degradation varied widely among the different tested feeds. We found a linear decrease in starch degradation with increasing mPS for barley, wheat, rye, and pea meals, whereas we noted a quadratic decrease in starch degradation for the other tested meals. Further, we observed a linear decrease in the rate of gas production with increasing mPS in each tested feed, except for pea meal, which had a quadratic relationship. For each 1 mm increase in mPS, the gas production was adjusted by ?0.009 h^?1 for corn, ?0.011 h^?1 for barley, ?0.008 h^?1 for wheat, and ?0.006 h^?1 for faba, whereas numerically greater adjustments were needed for oat (?0.022 h^?1), rye (?0.017 h^?1), and sorghum (?0.014 h^?1). These mPS adjustment factors could be used to modify the starch-based feed energy values as a function of mean particle size, although in vivo validation is required.     

Reduced basis method for managed pressure drilling based on a model with local nonlinearities

To circumvent restrictions of conventional drilling methods, such as slow control actions and inability to drill depleted reservoirs, a drilling method called managed pressure drilling (MPD) has been developed. In MPD, single-phase flow processes can be modeled as a feedback interconnection of a high-order linear system and a low-order nonlinear system. These nonlinearities appear locally both inside and at the boundaries of the computational domain. To obtain a fast simulation platform for real-time purposes (eg, online model-based controller implementation), model order reduction is required for MPD. However, the local nonlinearities render applying model order reduction techniques challenging. In this study, a new approach is proposed to deal with such nonlinearities within the reduced basis (RB) context and it is successfully tested on a model for MPD. Contrary to the classical RB technique, the proposed approach not only does not generate nonphysical spikes at the locations of these local nonlinearities but also yields high speedup factors. The obtained reduced-order model can be used for efficient online simulation and controller design for drilling systems with MPD.     

闭口闪点测定方法的对比分析

对我国常用的闭口闪点测定方法宾斯基-马丁闭口杯法、阿贝尔闭口杯法和泰格闭口杯法的测定原理进行对比分析，并采用这3种方法分别对2种有证标准样品、4种有机试剂样品和7种喷气燃料样品的闭口闪点进行测定。结果表明：这3种方法在适用范围、仪器结构、升温速率和点火操作要求等方面都有一定差异，导致采用这3种方法测定同一样品的闭口闪点结果略有差异，闪点测定结果之间的最大差值与样品闪点的高低呈正相关；与阿贝尔闭口杯法相比，宾斯基-马丁闭口杯法测得的闪点结果较高，对于3号喷气燃料，二者之差为0～1.0 ℃，阿贝尔闭口杯法更适合3号喷气燃料闭口闪点的测定；对于纯有机试剂样品，阿贝尔闭口杯法和宾斯基-马丁闭口杯法测得的闪点结果呈现较好的线性关系。